Idiomas disponibles
Idiomas disponibles
prevent accidental operation. When you push the
Safety Lock Off Lever it releases the Throttle Trigger.
F2
Selecting the speed
2 Power Levels can be selected depending on the
application. Use the +/- to control the speed, which
is as indicated by the LEDs. The higher the power
level, the faster the tool runs.
Stopping the trimmer
Release the Throttle Trigger to stop the machine.
WARNING! The cutting head continues to
rotate after the trimmer has been switched
off; wait until it has completely stopped then lay
down the tool.
Bump-line feed system (See Fig. G)
The trimmer is equipped with a bump-line system.
Just bump the trimmer head while the machine is
running, new line will feed out.
G
Cutting Tips (See Fig. H)
H
15m (50ft)
1. Swing the trimmer from side to side across the
area to be cut.
2. Use the tip of the cutting line to do trimming; do
not force the trimmer head into uncut grass.
3. Wire and picket fences may cause extra cutting
line wear and breakage. Stone and brick walls,
curbs, and wood may wear cutting line rapidly.
4. Avoid trees and shrubs. Tree bark, wood
moldings, siding, and fence posts can easily be
damaged by the cutting line.
5. The selected power level affects the battery's
runtime. The lower the power level, the longer
the runtime. It is recommended to use the lowest
power level unless in worse cutting condition.
For Battery tools
The recommended ambient temperature range for
discharging is -4°F~113°F (-20°C~45°C).
The recommended ambient temperature range for
the charging system during charging is 23°F~113°F
(-5°C~45°C).
15m (50ft)
TRANSPORTATION
Transporting the trimmer
1. Switch off the trimmer and remove the battery.
2. When transporting your trimmer by hand, hold
the middle of the shaft with the cutting head
to the rear and make sure that your machine is
parallel to the ground.
3. When transporting your trimmer in a vehicle,
secure and position it to prevent movement or
damage.
Transporting the battery
1. Ensure the battery is in a safe condition.
2. Use non-conductive packaging when
transporting the battery.
3. The contained Li-Ion batteries are subject to the
dangerous goods legislation requirements.
Transport batteries only when the battery
housing is undamaged. Pack up the batteries in
such a manner that cannot move around in the
packaging.
15m (50ft)
EN
13
