Idiomas disponibles
Idiomas disponibles
MAINTENANCE
WARNING! Always remove battery before
conducting any maintenance on the
trimmer.
Replacing the trimmer head (See Fig. I1, I2)
WARNING! Use of wire or metal-reinforced
line is not authorized and could be
extremely dangerous. Use only the cutting line
recommended in this manual, in combination
with the recommended debris guard.
WARNING! A damaged or loose cutting
attachment head may vibrate, crack, break
or come off the trimmer, which may result in
serious or fatal injury or property damage. Make
sure the trimmer head are properly and securely
tightened and in good condition before starting
work.
I1
EN
I2
1. Insert the torx key into the hole and rotate the
trimmer head to remove it.
2. Fit the Fan and the new cutting head. Insert the
torx key into the hole and rotate the trimmer
head counterclockwise until it stops in a locked
position.
WARNING: When installing the Fan, ensure
that the side with the "Outside" indicator is
facing outward.
14
Winding the line (See Fig. J1, J2, J3)
1. Rotate the spool cap until the two triangle icons
are aligned. (See Fig. J1)
J1
J2
2. Insert the replacement line through the eyelet
(Line In) and feed it out through the other eyelet.
Ensure both ends of the line are even on each
end of the trimmer head (recommended
6.6 ft (2 m) and cut the line. (See Fig. J2)
3. Turn the dial clockwise to wind the line around
the spool until about 6''(16 cm) remains on either
side. (See Fig. J3)
J3
6.6 ft
(2 m)
6.6 ft
(2 m)
