Idiomas disponibles
Idiomas disponibles
Payment
System
Set=up
PD Model Washer is coin payment ready and allows the use of
two different sizes of coins if a dual drop is installed. To set-up
the washer for coin payment, acquire a coin drop mechanism
with the appropriate
coin sensors. Connect coin sensors to the
coin slot 1 and 2, respectively.
Installing
Pad Strips
NOTE: For PD Models only.
1. Take the 2 foam pad strips from bag.
2. Remove tape from the back of adhesive pads.
3. Install the pads on the left and right inside walls of the coin
vault, leaving about 6 mm (1/4") to 13 mm (1/2") of space near
the front edge of the vault to allow room for the coin box to
lock into position.
A. Foam pad strips
A
Complete
Installation
1. Check the electrical requirements.
Be sure that you have
the correct electrical supply and the recommended
earthing
method. See "Electrical Requirements."
2. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
5. Check that the water taps are on.
6. Check for leaks around taps and inlet hoses.
Electric
Shock Hazard
Plug into an earthed socket outlet.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow
these instructions can result
in death,
fire, or electric
shock.
7. Plug into an earthed socket outlet.
8. To test and to clean your washer, measure 1/2 the detergent
manufacturer's
recommended
amount for a medium-size
load.
Pour the detergent into the detergent dispenser. Select any
cycle and allow the washer to complete one whole cycle.
10
