Idiomas disponibles
Idiomas disponibles
Winter Function
Press button 3 to activate the winter function. The fan will make air flow from the bottom
upwards, bringing cold air to the top of the room.
Summer Function
Press button 4 to activate the summer function. The fan will make air flow from the top
downwards, bringing cold air to the bottom of the room.
Warning:
Invert the spinning direction of the fan while in operation. Hold down the button for approx.
3 seconds: the appliance will beep, and the blades will start slowing down until they stop
spinning. After a few seconds, they will start spinning again in the opposite direction.
Natural breeze
Activate this mode by pressing button 5. The fan will run at different power levels in a cycle,
producing a feeling of fresh air.
Pairing the remote control with the fan
Press the power button for 5 seconds until you hear a beep.
Warnings:
-
The remote control operates through RF Wireless digital transmission technology. If both
the fan and the lamp are equipped with a switch, turn on the fan at top speed and turn
the light on before using the remote control.
-
If the fan or the light cannot be controlled through the remote control, check if the
batteries in the remote control are in good conditions and if they make good contact, that
the positive and negative electrodes are in the correct position, and if the batteries are
charged.
-
If the fan or the light cannot be controlled through the remote control, check if there are
other remote-controlled appliances in the same area and check if the transmitter buttons
are pressed. Appliances with similar remote-control systems may cause interference.
This does not include infrared remote controls.
-
Pay attention to the appliance voltage. Too low a voltage may cause the remote control to
not work. The technical specifications are indicated in this manual.
-
If the remote control is not going to be used for a long time, remove the batteries.
Changing the remote control battery
The remote control requires 2 x 1.5 V-3 AAA batteries.
1. Open the battery compartment.
2. Insert the batteries into the battery compartment observing the polarity.
3. Close the compartment.
ENERGYSILENCE AERO 5280 WHITEWOOD/BLACKWOOD
ENERGYSILENCE AERO 5285 WHITEWOOD/BLACKWOOD
ENGLISH
51
