cecotec ENERGYSILENCE 490 FRESHESSENCE Manual De Instrucciones página 52

ENGLISH
3. ASSEMBLY
1. Place the wheels (20) on the rubber bracket (19) and secure them with the screws (21) and
washers (22). Insert the support tube (23) into the base (18).
2. Place the main unit on its bracket and secure it with a nut (10).
3. Fit the rear grille (5) on the motor shaft. Fix it on the motor cover (8) with the fixing piece
(7).
4. Put the blades (4) on the motor shaft and fix them using the fixing cap (3).
5. Place the steam diffuser (1) into the front grille (2). Fix it using the screws.
6. Attach the front grille (2) to the rear grille using the ring (6). Fix them with the clamping
piece (7).
7. Connect the mist tube (13) to the top cover and the top cover to the steam diffuser (1).
4. OPERATION
ATTENTION:
- Make sure that the product is disconnected from the mains before filling or refilling the
water tank.
- Only put water in the water tank. Do not add any chemicals, oils, or other substances.
- Put only cold or lukewarm water in the water tank. Water used must not be above 40 °C.
Fig. 4 key:
- Valve cover
- Water tank
Filling the water tank
- Remove the water tank and turn it upside down.
- Unscrew the valve cap to open the tank by turning it counterclockwise. Fig. 4
- Fill the tank with cold, clean water, making sure not to overfill. To close the tank, screw the
valve cap back on by turning it clockwise.
- Turn the tank upside down and place it back into the designated space at the back of the
main fan unit. Fig. 5
A. ON/OFF: power button
- Press the POWER button to switch on the fan. The power indicator light (29) will light up
on the control panel.
- By pressing the POWER button when the fan is on, the fan will be switched off.
52 ENERGYSILENCE 490 FRESHESSENCE