Installation
Door and Drawer Removal
Some installations
require door/drawer
removal to
transport
the refrigerator
to its final location.
1. Unplug power cord from power source.
Pullout Freezer Drawer
2. Remove toe grille (see page 3).
3. Remove top hinge cover from
refrigerator
door by removing Phillips
screw and retain screw and cover for
later use.
4. Unscrew 5/,6"hex head screws from
top hinge to remove hinge and retain
all screws for later use.
5. Lift refrigerator
door from center
hinge pin.
6. Remove plastic sleeve, if present.
Remove center hinge pin with a _6" hex
head driver. Retain hinge pin and
plastic sleeve for later use.
7. Remove Phillips screws to remove
center hinge and retain all
screws for later use.
8. Remove bottom hinge or
stabilizing
bracket with 3/6"hex
head driver and retain screws
for later use. Lift out bottom
hinge pin (on freezer door
models).
9. See pages 4-5 for drawer removal
instructions.
@
To Remove:
1. Pull drawer open to full extension.
2. Pull upper basket out to full extension and lift out
to remove.
.
4.
Lift lower basket straight
up and out to remove.
On each side rail is a
basket cradle with two snap
attachments.
To release
each cradle, unlatch the
snaps by pushing them
inward, away from the side
rail system. Lift the cradles
off of the rails.
5. Remove Phillips screw from
each side of rail system (select
models).
6. Lift top of drawer front to
unhook supports
from rail
system. Lift door front out to
re move.