Technical Data; Noise; Transportation; Storage - Powerplus POWEG8013 Manual De Instrucciones

12 TECHNICAL DATA

Model
Engine
Cylinder content
Power
Tank content
Mowing width threading head
Wire diameter
Cutting width knife
Rotation speed grass trimmer
Rotation speed brush cutter
Spark plug

13 NOISE

Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION! Wear hearing protection when sound pressure is over 85 dB(A)
aw (Vibration)

14 TRANSPORTATION

▪
Turn off the motor during transportation of the tool.
▪
During transportation, the protection should be fastened around the blade.
▪
During transportation in a vehicle, the tool should be placed in such a way as to prevent
any fuel leakage.
▪
If your appliance is to be transported, the fuel tank must be completely emptied.
▪
When unloading your appliance from the vehicle after transportation, make sure that the
motor does not hit hard against the ground. This could cause severe damage to the fuel
tank.

15 STORAGE

Caution! Not following the following instructions may lead to deposits in the
carburettor and to permanent damage.
▪
Execute all the recommendations concerning maintenance specified in the
"Maintenance and care" chapter.
▪
Clean the engine outside surface, the shaft housing, the protective cover, and the string
attachment.
▪
Drain fuel from the tank.
▪
After fuel drainage, start the engine.
▪
Let the engine run at idle until it stops. Asa result of that, no fuel will remain in the
carburettor.
▪
Let the engine cool off (for approximately 5 minutes).
▪
Remove the spark plug with the spark plug key.
▪
Pour a little bit of 2-cycle engine oil into the combustion chamber. Pull the starter rope
grip a few times - oil will spread. Replace the spark plug.
Copyright © 2024 VARO
POWEG8013
POWEG8013
Air cooled 2 stroke engine
42.7 CC
1.25 kW
0.95 l
460 mm
2.4 mm
255 mm
8000 min-1
8500 min-1
CDK L7TC
88 dB(A)
106 dB(A)
7.5 m/s²
P a g e | 12
K = 1.5 m/s²
www.varo.com
EN