Idiomas disponibles
Idiomas disponibles
Saftey Information
IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING
DANGER!
WATER TEMPERATURE SETTING
Safety and energy conservation are factors to be considered when selecting the water temperature
setting. Water temperatures above 125°F can cause severe burns or death from scalding. The
thermostat is adjusted to its lowest temperature position when shipped from the factory. Be sure to
read and follow the warnings outlined on the label pictured below.
Water temperature over 125°F can cause severe burns instantly
or death from scalds. Children, disabled and elderly are at
highest risk of being scalded. See instruction manual before
setting temperature at water heater. Feel water before bathing
or showering. Temperature limiting valves are available, see
manual.
Turn water heater
Hold the button down for 5 seconds to get into
EZ connection mode (fast blink) and hold down
for another 5 seconds to get into AP connection
mode (slow blink) that produces a Wi-Fi hotspot to
8
Support: Support.Eccotemp.com
ON/OFF
connect to.
PLEASE NOTE: SHLX IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO
CHANGE WITHOUT NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR MORE INFORMATION.
Time / Temperature Relationship in Scales
Water Temperature
120
125
130
135
140
145
150
155
Table courtesy of Shriners Burn Institute
The chart shown above may be used as a guide in
determining the proper water temperature for your
home.
DANGER: Households with small children,
disabled, or elderly persons may require a 120°F
or lower temperature setting to prevent contact
with"HOT" water.
Maximum water temperature occurs while burner is on.
To find water temperature being delivered, turn on a hot
water faucet, place a thermometer in the water stream
and read the thermometer.
The temperature of the water at the outlet of the water
heater can be regulated by setting the temperature on
the Eccotemp Smart App (pg. 35-37) or by using the
included remote (pg. 34). The default temperature was
set at 118°F before it was shipped from the factory.
NOTICE: When this water heater is supplying general
purpose hot water requirements for use by individuals,
a thermostatically controlled mixing valve for reducing
point of use water temperature is recommended to
reduce the risk of scald injury. Contact a licensed
plumber or the local plumbing authority for further
information.
NOTICE: The factory recommended operating
temperatures are between 90°F and 140°F.
NOTICE! This is an automatic temperature controlled
tankless water heater. This means that the temperature
must be set from the Eccotemp app or remote control.
You can restrict the flow of the incoming water using the
built in flow restrictor in order to achieve a desired set
temperature. This tankless water heater is flow activated
and will adjust gas flames to heat water as necessary.
Shop Online: www.Eccotemp.com
Time to Product a serious Burn
More than 5 minutes
1 1/2 to 2 minutes
About 30 seconds
About 10 seconds
Less than 5 seconds
Less than 3 seconds
About 1 1/2 seconds
About 1 second
Phone: 866-356-1992
