Idiomas disponibles
Idiomas disponibles
Installing the SHLX
CHECKLIST
Water Heater Location
☐
☐
☐
☐
☐
☐
☐
☐
☐
☐
Water Supply
☐
☐
☐
☐
☐
☐
Gas Supply
☐
☐
☐
☐
☐
☐
Relief Valve
☐
☐
Electrical Wiring
☐
☐
☐
☐
30
Support: Support.Eccotemp.com
Installed INDOORS
Close to area of mostly used outlet
Protected from freezing temperatures
Proper clearance from combustible surfaces observed
Sufficient fresh air supply for proper operation of water heater
Air supply free of corrosive elements and flammable vapors
Provisions made to protect area from water damage
Sufficient room to service heater
Combustible materials, such as clothing, cleaning materials, rags, etc. clear of the heater and
vent piping
Water heater is properly attached to the wall
Water supply has sufficient pressure
Air purged from water heater and piping
Water connections tight and free of leaks
Water filter is clean and in place
Materials used are as instructed in this manual
Water pipes are insulated
Gas type matches rating plate
Gas supply pressure is sufficient for the water heater
Gas line equipped with shut off valve, union and sediment trap
Approved pipe joint compound used
Commercial leak detector or soap and water solution used to check all connections and
fittings for possible gas leak
Gas company inspected installation (if required)
Pressure relief valve properly installed and discharge line run to opendrain
Discharge line protected from freezing
Voltage matches rating plate
Water heater is properly grounded
Wiring meets all local codes
GFCI protection where required
PLEASE NOTE: SHLX IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO
CHANGE WITHOUT NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR MORE INFORMATION.
Shop Online: www.Eccotemp.com
Phone: 866-356-1992
