Idiomas disponibles
Idiomas disponibles
Installing the SHLX
MOUNTING
Sealant
At Least 3 Degrees
Exhaust Pipe
Outside
Back Installation
Φ3.5"
Hole for Pipe
2.5"
Wall Thimble
Side Installation
PLEASE NOTE: SHLX IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO
Support: Support.Eccotemp.com
Make sure the location of the water heater allows for easy access
and operation.
In case of dry wall, or concrete wall use dry wall anchors or lag bolts.
The water heater requires 120VAC/ 60Hz. Have a receptacle with
ground terminal near the water heater. The length of the power
supply cord is 5 feet.
Drill the holes as per the sizes in the figure to the left, put 2 expansion
screws into the top holes, and 2 rubber screws into the bottom holes.
Hang up the water heater, tighten the expansion screws, and put 2
wood thread screws into the bottom holes.
CAUTION: Reinforcement of the wall is required in case the wall
is not strong enough to hold the water heater.
Φ4.5"
Elbow
Inside
5.5"
Holes for
Brackets
Φ3.5"
5.5"
CHANGE WITHOUT NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR MORE INFORMATION.
Shop Online: www.Eccotemp.com
Indoor water heater must be installed with CAT 3
vent pipe in accordance with vent supplier/
manufacturer in accordance with local code.
Owner must refer to vent manufacturer's
instructions and specifications. Eccotemp
information can be found at www.Eccotemp.
com.
A. BACK INSTALLATION
1. Insert the vent pipe through the
installation holes in the wall with the terminal
sticking out.
2. Connect the elbow to the vent pipe and
water heater, moving straight backwards
until the expansion screws go into the holes
of the water heater. Screw the nuts tight
(pay attention to the direction of the elbow).
B. SIDE INSTALLATION:
1. Aim the holes in the water heater onto
the expansion screws, hang it up and screw
the nuts tightly.
2. Put the vent pipe through the holes in the
wall, and connect the elbow with the water
heater and vent pipe.
C. VERTICAL INSTALLATION
1. Please refer to local installation professional
or venting manufacturer:
2. The installation hole in the wall needs to be
sealed by fire-retardant material or wall thimble,
making sure the water heater is tight and will not
come off.
Phone: 866-356-1992
Designed in
Summerville, SC
29
