Makita AF505N Manual De Instrucciones página 6

Nose adapter
► 1. Nose adapter
CAUTION:
• Always disconnect the hose before installing the
nose adapter.
To prevent the surface of workpiece from being
scratched or damaged, use the nose adapter.
Connecting air hose
► 1. Air fitting 2. Air socket
Slip the air socket of the air hose onto the air fitting on
the nailer. Be sure that the air socket locks firmly into
position when installed onto the air fitting. A hose cou- pling must be installed on or near the tool in such a way
that the pressure reservoir will discharge at the time the
air supply coupling is disconnected.
1
2
1
OPERATION
To drive a nail, you may place the contact element
against the workpiece and pull the trigger.
CAUTION:
• WITH THE TRIGGER HELD IN A HALF-
PULLED POSITION, an unexpected nailing
could occur, if contact element is allowed to
re-contact against the workpiece or the other
surface under the influence of recoil.
In order to avoid this unexpected nailing, per- form as follows;
A. Do not place the contact element against the work-
piece with excessive force.
B. Pull the trigger fully and hold it on for 1-2 seconds
after nailing.
Direction of exhaust air
► 1. Exhaust cover
The direction of exhaust air can be changed 360
degrees of angle by turning the exhaust cover with a
hand.
Removing nails
CAUTION:
• Do not use deformed nails or nail strip. Failure
to do so causes poor nail feeding.
6 ENGLISH
1