Idiomas disponibles
Idiomas disponibles
You must use only approved connection blocks, which are
suitable for the appliance, i.e. there is a sign of compliance!
•
The electric cord must not be in touch with the hot parts
of the appliance!
•
You must never move the appliance by pulling it by
its electric cord. You must never use the electric cord for
moving of other objects.
•
Do not reel the electric cord round the appliance! Do not
use the appliance with its electric cord reeled – this is also
valid if a cable drum is used!
•
Do not press the cord and do not stretch it by sharp
edges. Do not place the cord over hot plates or in open fire!
•
Warning: In order to avoid a hazard for very young
children, this appliance should be installed so that the
lowest heated rail is at least 600 mm above the floor.
Note: This appliance is intended only for drying textiles
washed in water.
II.
PACKAGE FIG. 1
•
After unpacking the appliance you should check if
it is not damaged during transportation and if all the
components are included! In case that you find out any
damage or incomplete package you should connect with
your authorized retailer!
•
Do not discard the original packing box! It could be
used to store the appliance during transportation in order
damages to be avoided!
•
The disposal of the packing material should be done in
the appropriate way! Children should be prevented from
playing with the polyethylene bags!
MOUNTING ON A WALL FIG. 2
III.
1.
Please ensure that the walls of the installation location
without wires, pipes, etc., to ensure that the device can be
securely mounted on the wall
2.
WARRNING! In order to avoid harm to the user and
(or) third parties in case of a malfunction in the system,
it is necessary to install the appliance in rooms with floor
waterproofing and (or) drainage in the sewer. Do not under
any circumstances place objects that are not waterproof
under the device. If the device is leaking, you should
contact the nearest service center of the manufacturer in
your area.
3.
The appliance is intended only for vertical wall
mounting! Floor or ceiling mounting is forbidden!
4.
Never position the appliance right below a socket
outlet!
5.
The appliance should be assembled and connected by
a qualified electrician. The installation process should be
isolated from the mains before electrical connection works
are to be done.
6.
The power cord should not be in touch with hot parts
of the appliance!
7.
Do not use the appliance in rooms smaller than 4
square meters.
8.
The appliance inlet and outlet openings must not be
blocked! Distance between the appliance and the ceiling
is at least 0.2m. Distance on both sides of the appliance to
the wall is at least 0.25m.
English
IV.
MOUNTING
1.
Choose a good horizontal position, then mark 4 points
as suggestive dimensions on the drilling position, then
drill with a suitable drill holes at the marked locations in
the wall.
Warning: Be sure to keep the safety distances as shown on
the above drawing.
2.
Fit the fasten tube in the hole and fit the bracket on the
wall with screws
3.
Hang the unit on the bracket gently, after ensuring the
unit is right fixed, turn the lock in the bracket as picture
show.
Warning: Before using the heater, make sure it is
mounted tightly to the wall.
We thank you for choosing TESY Bathroom Towel
Heater TH 01 & TH 01 W B. This is a product, which
provides heating at 500W or 750W in cold weather in
accordance with the desired temperature conditions in
the room. The appliance will provide long-life service
if being correctly maintained and taken care of in
accordance with the manual.
OPERATION
V.
Control panel fig. 4
Indicator
Name
Standby mode
Heating mode
Comfort mode
ECO mode
Display
How to use:
•
Plug the appliance to type AC 220-240V 50-60Hz socket
accompanied with sound signal.
•
The indicator
lights up.
•
Press the button
to turn on the heater.
•
To stop the appliance from working, press the button
•
Unplug the product when it's not in use.
Clock and day of week setting:
1.
Press down the button
day of the week setting.
2.
The screen display " ". Press
from 1-7.
1
Monday
2
Tuesday
3
Wednesday
4
Thursday
5
Friday
6
Saturday
7
Sunday
Button
Name
ON/OFF button
Increase button
Decrease button
Mode selection
Timer settings
for 3 secs to enter clock and
and
to select the day
Usage and Storage Instructions
EN
7
