Idiomas disponibles
Idiomas disponibles
User manual
t
Main button
T1
• 4T
Main button
T1
T2
For dual button or dual trigger torches, the «high» trigger retains the same functionality as the single trigger torch . The «low» trigger is not active.
CONFIGURING THE SETTINGS
Units
End current
Starting current
Welding current
Cold current
Main button
T1
T2
Pulse duration
Spot duration
Crater-fill feature
Frequency
frequency
Rising current
Post-Gas
Pre-Gas
Stopping time
Starting time
Cold weather
Access to some of the welding parameters depends on the selected display mode: Settings/Display mode: Easy or Expert. Refer to the HMI ma-
nual.
MANUAL GAS PURGE
The presence of oxygen in the torch can lead to a decrease in mechanical quality and can result in less corrosion resistance. To flush the gas from the
torch, press and hold button no. 1 and follow the on-screen procedure. Refer to the HMI manual.
MMA (SMAW) WELDING MODE
INSTALLATION AND GUIDANCE
See power source manual.
PROCESS SETTINGS
Settings
Rutile
Electrode type
Basic
Anti-Sticking
ON-OFF
Access to some of the welding parameters depends on the selected display mode: Settings/Display mode: Easy or Expert. Refer to the HMI ma-
nual.
30
Translation of the original
t
instructions
T2
t
t
T3
<0.5s
<0.5s
>0.5s
%
This idling current is the next phase after the current is lowered.
t
t
%
This start-up bearing current is a warm-up phase before the current is raised.
A
Welding current.
%
Second welding current known as a «cold» welding current.
T4
T3
s
Manual or time-controlled spot pulse phase
s
Either manual or a set time.
s
Avoids cratering at the end of welding and the risk of cracking, particularly in light alloys.
Pulse frequency (setting guidelines):
- If welding with manual filler metal, then the F(Hz) is synchronised to the filler action,
Hz
- If the metal is thin and without filler (< 0.8mm), F(Hz) > 10Hz
- If welding in position, then F(Hz) < 100Hz
s
Allows a gradual increase in welding current.
Duration of the gas protection after the arc is extinguished. It protects the workpiece and the electrode from
s
oxidation during cooling.
s
When the torch is bled and the gas shield is created before ignition.
s
This idling time is a phase that comes after the current is lowered.
s
Starting time before the current is raised.
%
Pulsed hot current (I) time balance
Welding processes
Settings
Standard
T1 - The main button is pressed, the cycle starts from Pre-Gas and
stops at the I_Start phase.
T2 - The main button is released, the cycle continues to upslope
and welding.
T3 - The main button is pressed, the cycle goes to downslope and
stops in the I_Stop phase.
T4 - The main button is released, the cycle ends with the Post-Gas.
NB: for torches, double buttons and double button + potentiometer
=> «up/weld current» button turns on the potentiometer, the «down»
button turns it off.
T4
Pulsed
The type of electrode determines the settings in order to optimise its
weldability depending on the type of electrode used.
The anti-stick feature is recommended to safely remove the electrode in
the event of it sticking to the workpiece (the current is cut off automati-
cally).
WF 35
