Idiomas disponibles
Idiomas disponibles
necessary to replace it under special circumstances,
please contact the local QJMOTOR service station
for help. When replacing a damaged light source, be
sure to use a light source with the same rated power.
The use of light sources with different wattage
ratings may cause overload of the circuit system and
premature damage to the light source.
Note
When
replacing
the
light
specification as the original vehicle must be used. The
high-power light source will increase the load of the
circuit system, which will easily cause battery power
loss and other faults.
● Headlight Beam Adjustment
The headlight beam can be
adjusted up and down in the
vertical
direction.
The
source,
the
same
beam
height adjustment screw ① is located on the back of
the headlight. Turn the height adjusting screw ①
clockwise to lower the low beam and high beam
simultaneously; turn the height adjusting screw ①
counterclockwise to raise the low beam and high
beam simultaneously.
Note
When adjusting the beam height, the driver should sit
on the seat cushion of the vehicle, with both tires on
the ground, and keep the vehicle in a vertical state for
adjustment.
● ABS use and maintenance instructions
When the power lock is turned on, the ABS indicator
on the instrument panel will be on (not flashing),
which is normal. When the riding speed reaches
5km/H, the ABS indicator on the instrument panel
will go out, and the ABS is in normal working
55
