Black and Decker BD17203 Manual De Instrucciones página 6

Calentador de área de inducción rápida
Idiomas disponibles

Idiomas disponibles

• This heating appliance should not be used on
plastic or artificial wood decks.
• Children and adults should be alerted to the
hazards of high surface temperatures and
should stay away to avoid burns or clothing
ignition.
• Young children should be carefully
supervised when they are in the vicinity of
the heater.
• Clothing or other flammable materials
should not be hung from the heater, or
placed on or near the heater.
• Any guard or other protective device
removed for servicing the appliance shall
be replaced prior to operating the heater.
• Installation and repair should be done
by a qualified service person. The heater
should be inspected before use and at least
annually by a qualified service person.
More frequent cleaning may be required as
necessary. It is imperative that the control
compartment, burners and circulating air
passageways of the heater be kept clean.
• Storage of an appliance indoors is
permissible only if the cylinder is
disconnected and removed from the
appliance. A cylinder must be stored
outdoors in a well-ventilated area out of the
reach of children. A disconnected cylinder
must have dust caps tightly installed and
must not be stored in a building, garage or
any other enclosed area.
• Place the dust cap on the cylinder valve
outlet whenever the cylinder is not in use.
Only install the type of dust cap on the
cylinder valve that is provided with the
cylinder valve. Other types of caps or plugs
may result in leakage of propane.
• Installation of this appliance at altitudes
above 2000 ft (610 m) shall be in accordance
with local codes, or in the absence of local
codes, ANSI Z223.1/NFPA 54 or CSA B149.1.
• Appliance may shut down in windy
conditions in excess of 3 miles per hour (4.83
kilometers per hour).
• Only use the regulator and hose assembly
provided with this unit. Replacement parts
must be supplied
• Inspect the burner before use of this unit. If
the burner shows any kind of damage, do
not operate the appliance. For assistance
with repair or replacement of the burner
or any other parts, call the manufacturer at
1-877-447-4768.
You must follow all steps to properly assemble
this heating item. Make sure the gas valve
is turned 'OFF' before assembling. Do NOT
attempt to assemble without proper tools
BE CAREFUL: WHEN CERTAIN MATERIALS OR
ITEMS ARE STORED ABOVE, BESIDE
OR UNDER THIS HEATER WHILE IN USE,
THEY WILL BE SUBJECT TO RADIANT HEAT
AND COULD BE SERIOUSLY DAMAGED.
WARNING
Combustible materials should not be within
24 inches of the top of the unit, or within
24 inches around the entire unit.
HARDWARE
AA
M8 x 16 Screw
QTY 2
CC
M6 Nut
QTY 6
EE
BB
M6 x 12
QTY 6
DD
M5 x 12 Screw
QTY 5
FF
6
loading