Idiomas disponibles
Idiomas disponibles
Setting automatic closing time
The timer starts from the gate open state and continues for the set time. Once the set time is reached, the gate closes
automatically. The timer count restarts if a photocell is triggered.
Pause time settable from 00 to 90 s.
Pause time settable from 2 to 9 min.
Enabling of management for opening with automatic re-closure exclusion
If enabled, the exclusion of automatic re-closure only applies for the command selected via the parameter. For example:
if you set
command.
NOTE: The command has open-stop-close or close-stop-open sequence activation function.
Disabled.
An AP (opening) command activates the opening manoeuvre. When the gate is fully open, automatic reclosure is exclu-
ded. A subsequent AP (open) command activates the closing operation.
A PP (step-by-step) command activates the opening manoeuvre. When the gate is fully open, automatic reclosure is
excluded. A subsequent PP (step-by-step) command activates the closing operation.
A PED (partial opening) command activates the partial opening operation. Automatic reclosure is excluded. A subse-
quent PED (partial opening) command activates the closing operation.
Tolerance on opening stop
NOTE: parameter are visible if limit switches are disabled on parameter
than or equal to that of par.
= minimum tolerance (rotor revolutions) ...
Tolerance on closing stop
NOTE: parameter are visible if limit switches are disabled on parameter
less than or equal to that of par.
= minimum tolerance (rotor revolutions) ...
Advance on stop on full opening
NOTE: parameter are visible if limit switches are disabled on parameter
To set an advance on stop of approx. 3cm set the following values for parameter
for TW110/2000
for TW110/1000/HS
for TW110/1600/HS
for TW110/1200/R
= minimum advance (rotor revolution) ...
Advance on stop on full closing
NOTE: parameter are visible if limit switches are disabled on parameter
To set an advance on stop of approx. 3cm set the following values for parameter
for TW110/2000
for TW110/1000/HS
for TW110/1600/HS
for TW110/1200/R
= minimum advance (rotor revolution) ...
Setting reverse time after activation of sensing edge or obstacle detection (crush prevention)
This sets the reverse manoeuvre time after activation of the sensing edge or the obstacle detection system. The gate co-
mes to a stop after reversal dues to activation of the sensing edge or obstacle detection system at the end of manoeuvre
deceleration speed. As a result, the effective reversal manoeuvre time is slightly longer than the set time.
From 0 to 60 s.
Setting motor torque
Increasing or decreasing the value of the parameter increases or decreases motor torque and, as a result, adjusts
obstacle detection sensitivity.
Use values below
winds or very cold temperatures).
= -35%;
= -25%;
= default motor torque setting.
= +8%;
= +16%;
66
, automatic re-closure is excluded following an AP command, but it is activated following a PP or PED
ONLY for particularly lightweight installations not exposed to severe weather conditions (strong
= -16%;
= -8% (reduced motor torque = increased sensitivity).
= +25%;
= +35% (increased motor torque = reduced sensitivity).
(
= maximum tolerance (rotor revolutions)
= maximum tolerance (rotor revolutions)
(
= maximum advance (rotor revolutions)
(
= maximum advance (rotor revolutions)
); adjust the value of par.
(
) ; adjust the value of par.
)
:
)
:
to be less
to be
