Roger Technology ROGER BRUSHLESS B70/1THP Instrucciones Y Advertencias Para El Instalador página 59

9.1
Before starting
1. Select the automation system model installed with the parameter
KEY: HIGH SPEED Motor
SELECTION
MODEL
TW110/2000
TW110/1000/HS
TW110/1600/HS
TW110/1200/R
2. Select the position of the motor relative to the gate with the parameter
with the motor installed on the right hand side of the gate (seen from interior side).
OPENING ON THE LEFT
3. If limit switches enabled (
the mechanical stop
CLOSING LIMIT SWITCH
4. Check that the operator present function is not enabled (
OPEN STOP CLOSE
5. Move the gate into the closed position.
6. Press TEST (see TEST mode in chapter 9) and check the command signal and safety device states. If any safety
devices are not installed, jumper the relative contact or disable the device from the relative parameter ( ,
, , and ).
TEST
CLOSE
REVERSIBLE Motor
MOTOR TYPE
/
2000kg IRREVERSIBLE
1000kg HIGH SPEED
(see chapter 13 "Special Parameters for High Speed Motor")
1600kg HIGH SPEED
(see chapter 13 "Special Parameters for High Speed Motor")
1200kg REVERSIBLE
(see chapter 14 "Special Parameters for Reversible Motor")
OPENING ON THE RIGHT
): adjust limit switches so that, after activation, the gate stops slightly in advance of
OPENING LIMIT SWITCH
TEST
15 15
No
TEST
da da ta ta
No
with limit switches enabled
Yes
TEST
FC FC
with limit switches disabled
Yes
TEST
00 00
.
CONFIGURATIONS
. The default setting for this parameter is
).
SEE CHAPTER 16 and 17
Until ...
PROG
AP P-
Press and hold on
ACQUISITION
PROCEDURE
CHAP. 10.2
ACQUISITION
PROCEDURE
CHAP. 10.3
, ,
ACQUISITION
PROCEDURE
CHAP. 10.2
59