Aqua Medic Qube control Manual De Instrucciones página 6

Fig. 2: Connections at the Aqua Medic Qube
1. Manual adjustment channel B
2. Manual adjustment channel W
3. Socket for control cable
4. Outlet for control cable (for controlling several Qubes)
5. Power supply
The Qube control and remote control are not waterproof. Therefore, don't install them in wet, humid
places. Furthermore, they have to be protected from
Insert the plug of the Qube's power supply to be controlled into the socket 3 of the Qube control (Fig. 1). Then,
connect it by the connecting cable of socket 2 to the socket of the power supply of the Qube (see Fig. 2, No. 5).
The control cable has to be connected to socket 1 of the Qube control and in socket 3 of the Qube.
can be connected via socket 4 (Fig. 2) by using an additional control cable. This has to be plugged in socket 3
of the next Qube. The manual adjusting dials (Fig. 2, No. 1 and 2) are then inoperative.
Programming the Qube control:
To set the time, press the button with the clock symbol on the remote control. The minutes start flashing and
can be adjusted by using the +/- keys. By pressing the button with the clock symbol again, the hours can be
adjusted. By using the SAVE button, the time will be saved.
By pressing the EXIT button, the menu can be left without making any alterations. By pressing ON/OFF, the
Qube can be switched on and of manually. By pressing RESET, all programs will be reset to the original setting.
All settings are made in steps of 5%: 0 = 5%, 20 = 100%
1. Twilight phase
8:30 - 9:00 0 - 6 channel W
8:30 - 9:00 1 - 10 channel B
2. Sunrise
9:00 - 12:00 6 - 20 channel W
9:00 - 12:00 10 - 20 channel B
3. Daylight phase
12:00 - 17:00 20 channel W
12:00 - 17:00 20 channel B
6
corrosion from salt water.
More Qubes