Idiomas disponibles
Idiomas disponibles
CLEANING THE MOTORIZED NOZZLE & BLOCKAGES
The motorized nozzle may
accumulate debris such as string,
hair and fibers. This type of debris
can wrap around the brush
and diminish its ability to clean
effectively.
The EASYCUT™ blade in the
motorized nozzle will cut debris
accumulation away from the
brush roll.
Recommended: After every use,
clean the brush roll with the
EASYCUT™ system by stepping
on the button for 1-2 seconds
as illustrated while the vacuum
cleaner is operating. Repeat
above step more than 5 times for
better performance.
NOTE:
It is recommended to
use the EASYCUT™ system while
the battery is fully charged.
WARNING
The motorized nozzle contains
an EASYCUT™ blade. It has an
extremely sharp edge inside.
Do not touch the blade when
performing maintenance.
EASYCUT™
Button
Brush Roll Manual Cleaning
1. Make sure the vacuum cleaner
is turned OFF. Remove the floor
head from the handle assembly
and turn it over to access the
brush roll.
2. Unlock the brush roll tab using
a flat head screwdriver or
similar tool.
3. Lift the brush roll out of the
housing. Clean off debris and
anything wrapped around the
brush.
4. Place the brush roll into the
housing by aligning the end
to the brush drive side first,
then inserting the other end
correctly into place. When
installed correctly, the brush
roll will spin freely. Lock
the brush roll into place by
securing the locking tab back
into position.
- 15 -
