Idiomas disponibles
Idiomas disponibles
I I I . B AT T E R I E S A N D C H A R G I N G
To change batteries in your scooter:
1. Remove the seat and battery shroud. See fi gure 10.
2. Disconnect the battery tie-down strap(s).
3. Disconnect the front-to-rear harness. Unplug both battery harnesses by pulling each harness out of its mating
plug. See fi gure 12.
WARNING! Do not pull on electrical harness wires directly to detach them from the scooter.
Always grasp the connector itself when disconnecting the harness to prevent wire damage.
WARNING! Failure to unplug both battery harnesses and front-to-rear harness prior to separating
the front and rear sections could result in permanent damage to the scooter.
4. Disconnect the battery cables from the battery terminals by sliding back the terminal boots and unscrewing
the nut from the bolt. See fi gure 11.
5. Remove the old batteries from the battery wells.
NOTE: Some scooters have spacers installed to secure the batteries. You may want to remove the spacers for
safe keeping until the batteries are replaced in the scooter. See fi gure 11.
6. Place a new battery in each battery well. Face the battery terminals of each battery away from the seat post
with the positive (+) and negative (-) battery terminals positioned as shown in fi gure 12.
7. Connect the red battery cable to the positive (+) battery terminal on each battery.
8. Connect the black battery cable to the negative (-) battery terminal on each battery.
9. Reposition the terminal boots over the battery terminals.
10. Reconnect the battery tie-down straps.
11. Reinstall the battery shroud, the rear shroud, and the seat.
NOTE: If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag. Contact your
local waste disposal agency or your authorized Provider for instructions on disposal and battery recycling,
which is our recommended course of action.
NOTE: While replacing the batteries, you must use the battery jumper harness if using 2 lithium batteries in
parallel.
SC7132
19
