Installation; Technical Specifications; Safety Precautions; Location - Lincoln Electric 180 Manual Del Usuario

A-1
TECHNICAL SPECIFICATIONS 180 Amp units (K2481-1, K2515-1, K2659-1, K2689-1, K2698-1)
Standard Voltage/Frequency
230 V
208 V
Voltage/Duty Cycle
230 V 30%
208 V 30%
Welding Current Range
30-180 Amps
RECOMMENDED INPUT CABLE AND FUSE SIZES
Input Voltage/Frequency
230 V 60 Hz
Height
13.7 in
347 mm
1
If connected to a circuit protected by fuses use Time Delay Fuse marked "D".
Read entire installation section before starting

installation.

SAFETY PRECAUTIONS

WARNING
ELECTRIC SHOCK can kill.
• Only qualified personnel should perform
this installation.
• Only personnel that have read and under-
stood the POWER MIG Operating Manual
should install and operate this equipment.
• Machine must be plugged into a receptacle
which is grounded per any national, local
or other applicable electrical codes.
• The POWER MIG power switch is to be in
the OFF ("O") position when installing
work cable and gun and when connecting
power cord to input power.
---------------------------------------------------
INSTALLATION
INPUT – SINGLE PHASE ONLY
60 Hz
60 Hz
RATED OUTPUT
OUTPUT
Open Circuit Voltage
Fuse or Breaker Size
40 Amp Super Lag
PHYSICAL DIMENSIONS
Width
10.15 in
258 mm
WIRE FEEDER WELDER (180 MODEL)
Input Current
20 Amps @ rated output
20 Amps @ rated output
Current
130 Amps
130 Amps
34 V
1 Input Amps
20
Depth
17.9 in
454 mm
SELECT SUITABLE LOCATION
Locate the welder in a dry location where there is free
circulation of clean air into the louvers in the back and
out the front of the unit. A location that minimizes the
amount of smoke and dirt drawn into the rear louvers
reduces the chance of dirt accumulation that can
block air passages and cause overheating.

STACKING

WIRE FEEDER WELDER(180 MODEL) cannot be
stacked.

TILTING

Each machine must be placed on a secure, level sur-
face, directly or on recommended cart. The machine
may topple over if this procedure is not followed.
Voltage at Rated Amperes
20
17
Wire Speed Range
50 - 500 in/min.
(1.3 - 12.7 m/min.)
Power Cord
50 Amp, 250 V,
Three Prong Plug
(NEMA Type 6-50P)
Weight
64 Ibs
29 kg
A-1