Parkside PKIK 4.3 B3 Guia Rápido página 41

6.4 Unwinding / winding the gooseneck
Unwind or wind the gooseneck to
the desired length.
6.5 Using the Device
6.5.1 Switching the borescope on/off
To switch the borescope on, press and hold the On/Standby button [5] for
about 3 seconds until the display [1] illuminates. To switch the borescope off,
press and hold the On/Standby button [5] for approx. 1 seconds.
6.5.2 Lighting
There are 8 LEDs in the camera head [11]. You can switch on the lighting by
pressing the Light button [7]. Pressing this button multiple times will stepwise
increase the LED brightness. There are 10 adjustable levels. Once the highest
level has been reached, pressing the Light button [7] again will turn the light
off. If you change the brightness setting and then power the camera off and
back on, the light brightness will be reset to the default value.
This is a special lamp not suitable for domestic room illumination
but intended to illuminate the working space only.
PARKSIDE PKIK 4.3 B3
English - 39