Install The Mulch Plug; Set The Blade Height; Install The Battery Pack; Remove The Battery Pack - GreenWorks LME367 Manual Del Operador

EN
8.5

INSTALL THE MULCH PLUG

1. Remove the grass catcher.
2. Open the rear discharge door (5) and hold it.
3. Hold the mulch plug (8) by its handle and fit it in the
discharge chute.
4. Close the rear discharge door.
8.6

SET THE BLADE HEIGHT

The machine can be set to different blade heights.
1. Push the height adjustment button (17), move the height
adjust gear to a higher position to increase the blade
height.
2. Push the height adjustment button (17), move the height
adjust gear to a lower position to decrease the blade
height.
English
5
8
17
8.7

INSTALL THE BATTERY PACK

6
USE ONLY
24V BATTERY
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
USE ONLY 24V BATTERY. DO NOT USE DUAL-
VOLTAGE 24/48V BATTERY.
Both batteries should be installed into the compartments in
order to start the machine.
1. Open the battery door (6).
2. Align the lift ribs on the battery pack (14) with the
grooves in the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Do the same operation with the other battery.
6. Close the battery door.
The motor starts only when you put in the safety key (15).
8.8

REMOVE THE BATTERY PACK

1. Open the battery door(6).
2. Push and hold the battery release button(16).
3. Remove the battery packs(14) from the machine.
10
16
14
WARNING
WARNING
NOTE
NOTE
15