Idiomas disponibles
Idiomas disponibles
1.0 - GENERAL INFORMATION
This manual explains how to safely install, operate and use the device.
The user instructions must ALWAYS be available in the system where the device is installed.
ATTENTION: the installation/wiring/maintenance operations must be carried out by qualified
personnel (as indicated in 1.3) using suitable personal protection equipment (PPE).
For any information relating to installation/wiring/maintenance operations or in the event of problems that cannot be resolved
with the use of the instructions, it is possible to contact the manufacturer using the address and telephone numbers listed on
the last page.
1.1 - DESCRIPTION
Normally closed automatic shut-off solenoid valves for gas, which open when the opening system is electrically powered and
close when the voltage is removed. They can be controlled by pressure switches, thermostats, etc.
Built-in flow controller with opening speed adjustment (XVPR/NC versions).
They can be supplied with CPI switch for remote signalling of the valve shutter (closed) position and OPI switch for remote
signalling of the valve shutter (open) position. Further information regarding the CPI and OPI switches can be found in 6.0.
Reference standards: EN 161 - EN 13611 - EN 60079-0-7-14-15-31.
1.2 - SYMBOLS LEGEND
DANGER: In the event
of non-compliance,
damage to material
goods can be caused.
1.3 - QUALIFIED PERSONNEL
These are persons who:
• Have experience with the installation, assembly, commissioning and maintenance of the product;
• Are aware of the regulations in force in the region or country regarding installation and safety;
• Have first aid training.
1.4 - USE OF NON-ORIGINAL SPARE PARTS
• In case of maintenance or replacement of spare parts (e.g. opening system, etc.) ONLY those indicated by the manufacturer
must be used. The use of different components, in addition to voiding the product warranty, could compromise its correct
functioning.
• The manufacturer is not responsible for malfunctions resulting from unauthorised tampering with or the use of non-original
spare parts.
1.5 - INAPPROPRIATE USE
• The product must only be used for the purpose for which it was built.
• It must not be used with fluids other than those indicated.
• The technical data indicated on the plate must never be exceeded. It is the responsibility of the end user or installer to adopt
correct systems to protect the appliance that prevent the maximum pressure indicated on the plate from being exceeded.
• The manufacturer is not responsible for damage caused by improper use of the appliance.
Madas Technical Manual - 1|1.2eX - REV. 1 of 18
DANGER: In case of non-
compliance, as well as damage to
material goods, damage to persons
and/or pets may be caused.
11
Oct 2023
th
ATTENTION: Attention
is drawn to technical
details aimed at qualified
personnel.
XVPF/NC - XVPR/NC
