Idiomas disponibles
Idiomas disponibles
Connecting data
If you need to connect cables to the vehicle supply network, strictly observe the following
instructions:
Before you connect a seat heater, you must obtain the relevant electrical data for the
respective vehicle with reference to voltage, protection and the kind of connections from the
manufacturer, from GRAMMER AG or the company's agencies.
For safety reasons, the installation and connection to the vehicle supply network must be
carried out by authorized specialist personnel only.
The seat connections must be protected independently of other vehicle components.
Seat heater
24V DC
10A
For pneumatic connection, the following data have to be observed:
Operating pressure
Max. 10 bar / Min. 6,5 bar
For establishing an electrical connection, select an electric circuit by means of which the
electric loads and components of the driver's seat are separated from the live network when
the ignition is switched off.
Guarantee and liability
GRAMMER AG does not disclaim any guarantee or liability for damage resulting from
incorrect assembly, use or repair of the driver's seats.
Further details on the claims admitted by GRAMMER AG are stated in your contractual
documents (see invoice or delivery note). Claims against GRAMMER AG other than the
claims described in those documents are excluded.
Subject to design, technical and equipment modifications as well as homologation regulations.
20
Air connection
Supply air = black / Exhaust air = grey
