Idiomas disponibles
Idiomas disponibles
Description of errors
Memory Check error:
This error occurs if a memory read-after-write check or FROM sum check has resulted in an error
(unrecoverable error).
Cover open:
When you open the printer cover, the cover open sensor is activated, causing the ERROR lamp to
light and the printing operation to stop. (Not recoverable error)
Head overheat:
To protect the print head from overheating, the head temperature sensor is activated if the head
temperature rises over approx. 65°C, causing the ERROR lamp to blink and the printing operation to
stop. Printing resumes automatically when the head temperature lowers below approx. 60°C. (Auto
recoverable error)
Paper near-end:
As the paper roll diameter becomes small, the Paper near-end sensor is activated and causes the
ERROR lamp to light, indicating the paper supply has become low. (See "Selecting the paper sensor
valid for paper end signal output" and "Selecting the Paper Near-End Sensor valid for print stop".)
Paper end:
When the paper roll has run out, the Paper end-sensor located near the print head on the paper
path detects the end of the paper roll, causing the ERROR lamp to light and printing to stop. (See
"Selecting the paper sensor valid for paper end signal output" and "Selecting the Paper Near-End
Sensor valid for print stop".)
Cutter motor lock:
While the cutter motor is running, if the cutter position detecting sensor inside the cutter unit
remains ON or OFF for approx. 1 second or more, the printer determines that the motor has locked,
causing the cutter operation and printing to stop. (See "Removing Jammed Paper".)
Low voltage error:
Occurs when the voltage supplied to the printer decreases ; if this has occurred, turn the power off
immediately. (Not recoverable error)
High voltage error:
Occurs when the voltage supplied to the printer increases ; if this has occurred, turn the power off
immediately. (Not recoverable error)
Waiting for label cutter action:
Wait until the label discharged by the GS+FF (Cut Label and Discharge) command is cut by the
manual cutter and the FEED switch is pressed. If "No Cutter" or "No Peeling Mechanism" is
selected, the printer becomes Busy.
Waiting for Label Discharge:
Waiting for a label to be removed from the base sheet after it was discharged by the GS+FF (Cut
Label & Eject) command (if the peeler is selected). The printer becomes Busy.
Label detection error:
Label gaps or black marks could not be detected, or the label sheets used do not fall in the specified
length limits.
If a label detection error occurs even though the label sheets used fall in the specified length limits,
it is most likely that the sensor or its peripheral electronics is defective. The printer becomes Busy.
— 19 —
Capítulos
