Orbis VIARIS UNI Manual De Usuario página 78

Charger connected to the vehicle,
the status bar is solid white and does
not charge.
Charger connected to the vehicle and
an hourly schedule but not charged
The protections of the installation are
triggered
After manual deactivation or with
RFID card the charge does not stop.
After the charging
charger is still connected to the vehicle
with the locked plug, fixed green status
bar.
Exceeding maximum power.
It takes a long time to charge my
vehicle with a three-phase supply.
process, the
77
Status reserved, for example, in an
updated situation; wait for the re-
served status to end.
If the time programming indicator
( ) is illuminated in red, the vehicle
does not support an external time
schedule. Schedule the time interval
on the vehicle itself and remove the
time schedule from the charger.
If the charge modulation indicator is
off, the TMC100 is not properly con-
nected: Check connection to the
terminals, direction of current and that
the TMC100
clamped in position as indicated in
the Charger Modulator section.
If the charge modulation indicator is
on ( ), the adjusted power does not
match in-coming power supply.
Unlock the hose using the car controller.
If it has been activated with an RFID
card, verify that it is the same one that
was used in the activation or that it is
authorised.
If the problem persists, release and
disconnect the vehicle hose
Unlock the hose using the car controller.
The modulator hasn't worked.
Check the configuration according to
the incoming power supply.
If you are charging a single-phase
vehicle, you will only be using approx-
imately 1/3 of the charging supply
securely fitted and
.