Orbis VIARIS UNI Manual De Usuario página 69

CHARGING PROCESS
VIARIS UNI can be activated by touch or RFID.

If configured for touch anyone can activate the charger.

If configured for RFID card – only the RFID card holder can activate
the charger.
These settings can only be configured via the e-VIARIS mobile app. (See
mobile app setting below).
.
Starting vehicle charge
By Touch:

Ensure charger is ON.

Connect the electric vehicle to the Smart Charger.

Start charge by touching activation zone.
By RFID:

Ensure charger is ON.

Connect the electric vehicle to the Smart Charger.

Hold the RFID card close to the activation zone until you hear a con-
firmation signal.

The charging of the electric vehicle will begin.
Charging by Time Schedule:

Ensure charger is ON.

Connect the electric vehicle to the Smart Charger.

Charging will begin at the programmed time.

To recharge your electric vehicle manually when there is a time
schedule, you must pass the RFID card twice.
NOTE: You will not be able to remove the charging cable from the vehi-
cle during the charging process as it is locked by a safety system.
Stopping Vehicle Charge
To stop the charge manually tap activation with touch or RFID until con-
firmation signal is heard.
Fully Charged
Charging automatically ends when the vehicle is fully charged unless
manually stopped by touch or RFID card.
68