Tabla de contenido
Idiomas disponibles
Idiomas disponibles
These programs are:
P-3.- Relaxation,
coordination.
Duration 10 minutes.
P-2.- Toning.
Duration 10 minutes.
P-1.- Boost.
Duration 10 minutes.
The program is shown on the monitor
display (A) by pressing the Program
key.
Press the Program key again to
select the exercise that you wish to
perform.
Next, press the START key to set the
platform in motion. When the program
finishes the monitor will beep to
indicate the end of the exercise.
Switch the platform off by pressing the
ON/OFF
key and the switch (L),
Fig. B.
The profile graphs for these preset
programs can be found at the end of
this instruction book.
REMOTE CONTROL.-
FITTING THE BATTERIES.
This
monitor
ALKALINE BATTERIES. To fit the
batteries, take the cover off the back
of the remote control (B) and carefully
insert the two «AAA» type batteries
into the battery compartment (A),
Fig.1, making sure that the batterys'
polarity
is
correct
battery «+» terminal with the «+» sign
inside the battery compartment, and
the «-» terminal with the «-» sign).
Replace
the
cover (B).
circulation
uses
two
1.5
(matching
battery
compartment
OPERATION.-
and
For
greater
exercising this platform has a remote
control unit to select the different
operation modes.
Remote control key list:
1.- Remote control
unit ON LED
2.- Remote control
ON/OFF button
3.-
START/STOP
key
4.- Increase ▲ or
decrease ▼ speed
keys
5.- Increase ▲ or
decrease ▼ time
keys
6.- Balancing key: Low, Medium or
High.
7.- Program selection key.
Note:
To ensure a good
signal between the
remote control unit
and the monitor,
point the remote
control at an angle
of
approximately
45º, as shown in
volt
the diagram.
MOVEMENT & STORAGE.
The unit is equipped with wheels (Y),
Fig.3, to make it easier to move.
Make sure that the mains cable is
unplugged from the wall socket.
the
Pull out the handle (D) in the direction
of the arrow
the platform in the direction of the
arrow
on the floor.
To prevent accidents DO NOT move
the platform across uneven floors.
14
ease
of
, as shown in Fig.3. Lift
, so that the wheels (Y) rest
use
when
Tabla de contenido
