Idiomas disponibles
Idiomas disponibles
OPERATION
WARNING:
Do not operate blower without tube
securely in place. Never reach down into housing through tube hole.
WARNING:
Always remove the battery when:
• You leave blower unattended or when storing.
• Checking, adjusting, cleaning, or working on blower.
Installing and Removing the Battery Pack
(Fig. 6)
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack (F) into the tool handle, align the battery
pack with the rails inside the tool's handle and slide it into the handle
until the battery pack is firmly seated
in the tool and ensure that it does not
disengage.
To remove the battery pack from the
tool, press the release button (G) and
firmly pull the battery pack out of the
tool handle. Insert it into the charger
as described in the charger section of
this manual.
FUEL GAUGE BATTERY PACKS (FIG. 7)
Some D
WALT battery packs include a fuel gauge which consists of
e
three green LED lights that indicate the level of charge remaining in
the battery pack.
The fuel gauge is an indication of approximate levels of charge
remaining in the battery pack according to the following indicators:
To actuate the fuel gauge, press and hold the fuel gauge button (G).
FIG. 6
A combination of the three green LED lights will illuminate designating
the level of charge left. When the level of charge in the battery is below
the usable limit, the fuel gauge will not illuminate and the battery will
G
need to be recharged.
F
NOTE: The fuel gauge is only an indication of the charge left on the
battery pack. It does not indicate tool functionality and is subject to
variation based on product components, temperature and end-user
application.
For more information regarding fuel gauge battery packs, please
contact call 1-800-4-D
www.dewalt.com.
10
75–100% charged
51–74% charged
< 50% charged
Pack needs to be charged
FIG. 7
G
WALT (1-800-433-9258) or visit our website
e
