The Menu; Operating The Menu - Mettler Toledo BPA224 Instrucciones De Manejo

METTLER TOLEDO BPA224 Scales
8
Weighing with limit values
Weighing in Weighing Mode is made easier for you by the two LEDs above the UNDER and OVER symbols
as well as a beep. The behavior of the two LEDS and the beep depend on the respective setting in the menu
(Chapter 4.2, menu item S3). The table below shows how the two LEDs and the beep behave for various
settings in menu item S3.
S3 = No load on balance
1
UNDER OVER UNDER OVER
2
UNDER OVER UNDER OVER
3
UNDER OVER UNDER OVER
4
UNDER OVER UNDER OVER
5
UNDER OVER UNDER OVER
6
UNDER OVER UNDER OVER
4

The menu

The menu can be used to change the settings of the scale and activate functions. The menu consists of
two parts, the user menu and service mode (see overview in Chapter 4.2). The user menu contains
frequently used settings and functions and is easy to call up. Service mode provides the same possibilities
as the user menu as well as additional functions for the service technician. To call up service mode a tool
is required.
4.1

Operating the menu

a
S1 OFF
Load < lower limit value Load between limit values Load > upper limit value
UNDER OVER
UNDER OVER
UNDER OVER
UNDER OVER
UNDER OVER
UNDER OVER
Calling up the user menu
With the scale switched off, press the a key and hold it down.
c
Switch on the scale with the c key.
"Setup" appears briefly in the display and then the first menu block of
the user menu ("S1") appears.
Calling up service mode
With the scale switched on, remove the cover of the storage battery
underneath the scale (6 screws). Remove the calibration plate (2
screws). To remove the calibration plate, the sticker has to be
destroyed which covers one of the two screws.
Use a small flat-tip screwdriver to short-circuit the two contacts in the
rectangular opening (see arrow).
UNDER OVER
UNDER OVER
UNDER OVER
UNDER OVER
UNDER OVER
UNDER OVER
UNDER OVER
UNDER OVER
UNDER OVER
UNDER OVER
UNDER OVER
UNDER OVER