Goodyear GY 702TL Manual De Instrucciones página 32

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
English
Owner´s manual
REGULAR SERVICE PERIOD
Spark plug, Clean readjust
Transmission gear oil, Check level
Tappet clearance, Check readjust
Fuel tank and strainer, Clean
Clutch cable, Adjust
Throttle cable, Adjust
Belt tension, Adjust
Fuel line, Check
OBSERVATION:
(1) Perform maintenance more frequently if you work in dusty areas.
(2) These tasks must be carried out by your Technical Service.
1. Changing engine oil
Drain the oil while the engine is still warm to assure rapid and complete drainage.
• Remove the oil filler cap and drain the oil.
• Refill with the recommended oil and (see page 28) check its level.
Oil capacity: 0.6 L
Wash your hands with soap and water after touching used oil.
NOTE
Please dispose used motor oil in a manner that is compatible with the environment. We suggest you put it in a sealed
container to your local service for reclamation. Do not throw it to the trash can or pour it on the ground.
2. Air cleaner service
A dirty air cleaner will block air flow into the carburetor. To prevent carburetor malfunction, service the air
cleaner regularly. Service more frequently when operating the engine in dusty areas.
WARNING: Never use gasoline or low flash point solvents to clean the air cleaner element. A fire or explosion could result in.
CAUTION: Never run the engine without air cleaner, or engine will be worn out rapidly.
1) Remove the wing nut and the air cleaner cover. Remove the elements and separate them. Carefully
check elements for holes and tears, and replace it if damaged.
2) Foam element: clean in warm soapy water, rinse and allow to dry thoroughly or clean in high flash-
point solvent and allow to dry. Dip the element in clean engine oil fill up the level indicated on it and
squeeze out all the excess. The engine will smoke during initial start –up if too much oil is left in the
foam.
3. On paper elements lightly tap the element several times on a hard surface to remove excess dirt or
blow compressed air through the filtor from the inside out. Never try to brush off dirt: brushing will
force dirt into the fibres.
32
First month
Daily
3 months
or 20 Hrs
or 50 Hrs
o
o
o
Every 2 years (2) (Replace if necessary)
Every
Every
Every year or
6 months
or 100 Hrs
o
300 Hrs
o (2)
0 (2)
o
loading

Este manual también es adecuado para:

Gy 703tl