Idiomas disponibles
Idiomas disponibles
Operation
individual requirements, turn the
thermostat control clockwise all the
way to turn on the heater. When the
room reaches the desired tem-
perature, turn the thermostat knob
counter-clockwise until you hear a
click. Leave thermostat in this posi-
tion to maintain the room tempera-
ture at this setting. For additional
heat, turn clockwise until you hear
the click again and the heater will
turn on.
* Only applicable when the Dimplex
heater has been plugged into the
receptacle.
Remote Control
The On/Off Switch must be in the
'ON' ( I ) position in order for the
remote control to operate. There
are 3 buttons on the remote control.
(Figure 9)
!
NOTE: To operate correctly,
the remote control must be pointed
towards the remote control sensor.
The remote control functions are as
follows:
Press once to turn on Flame
effect only. This will be indi-
cated by one beep.
Press once to turn on heat
and Flame effect. This will be
indicated by two beeps.
Standby - This will be indicated
by one beep.
12
!
NOTE: Once the mist has been
activated, the unit will have to be
turned Off, using either the switches
on the unit, or the standby button
on the remote control, then back on
to return to flame effect operation
only.
Battery Replacement
To replace the battery:
1.
Slide battery cover open on the
remote control (Figure 9).
2.
Install two 1.5 Volt (AAA) bat-
teries in the battery holder.
3.
Close the battery cover.
Battery must be recycled or
disposed of properly. Check
with your Local Authority
or Retailer for recycling advice in
your area.
Figure 9
Flame
Button
Standby
Button
Heat
Button
Battery Cover
www.dimplex.com
