DELTA DORE TYDOM 2.0 Manual De Utilización página 19

3. Correct operation test
Create a detection event to check that the installation is operational.
Switch on the system, and trigger an intrusion. Allow the call
cycle to run without touching the OFF button of a control
device.
Check that TYDOM 2.0 calls the programmed numbers
(6 at most) one after the other until a contact picks up:
- It reads the voice message and specifies the type of defect,
- It asks if you want to listen to what is happening, speak to a
person close to TYDOM 2.0, stop the call cycle and obtain the
details of the defects if an alarm control unit is associated.
From TYDOM 2.0:
>30s
You can also trigger a test call cy-
cle by pressing the TYDOM 2.0's
button for 30 seconds.
"You are To view the defect details,
connected with type 1
a telephone
transmitter"
Intruder alarm
25 June 2015
Garage door
intruder alarm,
on 25 June 2015
To disable the product,
press 1
1 7 13
n°1 n°1
2 8 14
n°2 n°2
3 9 15
n°3 n°3
4 10 16
n°4 n°4
5 11
n°5 n°5
6 12
n°6 n°6
Example of a full cycle
with 6 programmed numbers
To stop the call cycle,
press
1 2 3 1 2 3
4 5 6 4 5 6
7 8 9
7 8 9
0 * 0 #
- the system is off - to listen,
press 2
- to listen whilst talking, press 3
- to disconnect the call,
press twice
1 2 3
4 5 6
7 8 9
0
36
4. Telephone line LED status
LED T1
Green on and steady
n°1
Flashing green
n°2
Flashing green/orange
n°3
Red steady
n°4
5. Backup mode
5.1 Mains power failure
After 5 minutes of power failure, TYDOM 2.0 sends a notification to the alarm
control unit. The alarm control unit beeps.
TYDOM 2.0 sends you a notification of the power defect and continues sending
alarms via the GSM connection for 24 hours.
It is no longer controllable remotely.
After the 24 hour period, TYDOM 2.0 switches to energy saving mode, no other
function is available.
As soon as the mains power supply is restored, an end of defect notification is
sent to the alarm control unit.
The battery is designed to backup 22 power failures for 10 years.
Power
failure
5 mn
TYDOM 2.0
beeps
every 10 seconds
During a power failure, the video transfer function is not available.
The transfer of video links will resume when the power and Internet access are restored.
System status
System accessible locally
and remotely
Good GSM signal and IP connection OK
GSM call in progress or IP connection in
progress
Weak GSM signal and IP connection OK
No IP address allocated or no
GSM signal
24 h
Backup mode
alert transmission
37
LED T1
EN
Switches to
energy saving mode