Shark RS-JET CARBON Manual página 32

WARNING! This visor is attached
in such a way that it will not be
possible to instantly remove it from
your field of vision with one hand, in
the event of an emergency (glare or
fogging).
VISOR ASSEMBLY
1 - Present the visor slightly inclined in
front of its housing. Insert the visor into
its housing and push until it clicks.
Repeat the operation on the other side.
Close the visor.
To adjust the tightness of the move-
ment of the visor, tighten (Fig. A.) or
loosen (Fig. B.) the visor adjustment
screws using the wrench provided here.
Caution: proceed in stages to maintain
equal pressure on both sides.
WARNING! If you are not sure
that the visor has been reassembled
correctly, do not use your helmet.
While riding, the visor could detach
from the helmet suddenly and without
warning, causing a loss of control of
your motorcycle, resulting in an
accident, injury or death. We advise
you to contact your retailer for any
assistance and advice. If you are riding
at high speed, do not open the visor. It
could come loose and leave your eyes
and face unprotected.
Additionally, your head could be
pulled backward or sideways, which
could cause you to lose control of
the motorcycle, causing an accident,
1 1
personal injury or death.
A A
B B
13