Shark RS-JET CARBON Manual página 29

DISASSEMBLY OF THE INTERIOR
We recommend carrying out these
operations in Jet configuration:
- Turn your helmet over;
- Separate the two parts of the chin
strap;
- Release the rear part of the liner out
of its housing (Fig. A);
- Remove the neck guard by grabbing
one of its side parts and then the
other (Fig. B);
- To finish, unclip the liner support
starting from one side (Fig. C) and
remove the liner;
- Detach both cheek pads (Fig. D),
and slide them along the straps of the
chin strap to remove them.
WARNING! Interior positio-
ning is critical for keeping
the helmet on your head. If you are
unsure about disassembling or reas-
sembling the interior, do not use
your helmet. Contact your retailer
for assistance and advice. Never use
a helmet missing any part making
up its interior; it will not protect
you in the event of an accident.
WARNING! The shell and in-
ner liner are made to fit per-
fectly on your head. In the event
of an accident, a helmet that does
not fit you may come off, leaving
your head unprotected and cau-
sing serious or even fatal injuries.
If you are not sure that the interior
has been reassembled correctly, do
not use your helmet. Contact your
retailer for assistance and advice.
10
A
B
C
D