Shark RS-JET CARBON Manual página 27

WARNING! Never use the loop as
the only closure for the chin strap.
In order to be properly tightened, the chin
strap must pass through the double-D ring
strap according to the instructions. Any
improper use of the chin strap can cause
your helmet to be expelled in the event of
an accident, leaving your head without any
protection. Try pulling on the chin strap
with your fingers. If the strap becomes
loose in any way, you have not closed the
DOUBLE-D RING STRAP
1. Slide the longest part of the chin strap
through the two rings, while ensuring that
the comfort pad is correctly positioned
between the
See Figure A.
2. Make a loop with the end of the
chin strap around the outer ring and
pass it back through the inner ring.
See Figure B.
C
8
strap and the neck.
chin strap correctly in the double-D ring
straps. Then repeat the steps described
opposite. Never ride with the chin strap
open, incorrectly closed or incorrectly
positioned. Even if your cheeks feel like
the helmet provides a secure fit, it would
be ejected in an accident, leaving the head
without any protection. If in doubt about
the helmet closing system, do not use
the helmet. Ask your retailer for advice.
3. Pull on the end of the strap until the chin
strap is properly tightened.
The chin strap should be positioned
against the neck, not under the chin. It
should be as tight as possible without
hurting or hindering breathing.
See Figure C.
4. Press in the snap on the free end of the
strap to prevent the strap from trailing in
See Figure D.
the air.
B
D