Idiomas disponibles
Idiomas disponibles
2. Enter the code [9] [8] [1], the status LED flashes 2 times and then
lights up permanently again.
3. Press the button whose function you wish to
want to delete. The status LED flashes 3 times and the desired
function is deleted.
6.4.2 Deleting all taught functions
1. Press and hold the [MUTE] and [VOL+] buttons simultaneously for
approx. 3 sec. until the status LED lights up continuously.
2. Enter the code [9] [8] [2], the status LED flashes 2 times and then
lights up permanently again.
3. Press the [OK] button, the status LED flashes 3 times and all taught-
in functions are deleted.
7. EASY mode
This remote control is equipped with an EASY mode function. This
allows you to limit the range of functions of this remote control to
essential functions. This prevents an accidental change of the TV
settings.
In EASY mode, the following buttons are available:
Switch the TV set on/off
Change the volume
Mute the TV
Change the programmes
0-9
Direct programme input /
Teletext page direct call
TXT
Video text ON/OFF
Selection of on-screen options
EPG
Display of the programme guide
(if supported by the TV set)
Signal source selection
EXIT
Close menu
7.1 Activating EASY mode
1. Press and hold the [MUTE] and [SHARE SCREEN] buttons
simultaneously for approx. 3 sec. until the status LED lights up
continuously.
2. Enter the code [9] [7] [0], the status LED flashes 2 times and then
lights up permanently again.
3. Press the [OK] button, the status LED flashes 3 times and EASY
mode is activated.
7.2 Deactivating EASY Mode
1. Press and hold the [MUTE] and [SHARE SCREEN] buttons
simultaneously for approx. 3 sec. until the status LED lights up
continuously.
2. Enter the code [9] [7] [0], the status LED flashes 2 times and then
lights up permanently again.
3. Press the [EXIT] button, the status LED flashes 3 times and EASY
mode is deactivated.
Note
If the remote control is in EASY mode, only the buttons indicated
in point 7 function. If one of these buttons is pressed, the status LED
lights up until the button is released. In normal mode, the status LED
ashes when a button is pressed.
8. Care and maintenance
• Never use old and new batteries in the replacement remote control
at the same time, as old batteries tend to leak and can lead to a loss
of performance.
• Never clean the replacement remote control with scouring agents or
harsh cleaning agents.
• Keep the replacement remote control free of dust by cleaning it with
a dry soft cloth.
9. Troubleshooting
Q. My replacement remote control does not work!
A. Check your TV. If the main switch on the device is off, the
replacement remote control cannot operate the device.
A. Check that the batteries are inserted correctly and that the polarity
has been observed.
A. Check that you have pressed the appropriate device button for the
device.
A. Replace the batteries if the battery level is low.
Q. My TV only responds to some button commands.
A. Try other codes until most of the buttons work properly.
F. Some button commands on the remote control are no longer
working?
A. EASY mode may be activated. Deactivate EASY mode as described
in point 7.2.
10. Warranty disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for
damage resulting from improper installation/mounting, improper use of
the product or from failure to observe the operating instructions and/
or safety notes.
VIII
