AEG IKE42640KB Manual De Instrucciones página 102

A
< 20 mm
min. 500 mm
A B
12 mm 57 mm
28 mm 41 mm
38 mm 31 mm
A
> 20 mm
A B
12 mm 57 mm
28 mm 41 mm
38 mm 31 mm
102 ENGLISH
min. 2 mm
B
min
30 mm
min. 2 mm
B
min. 500 mm
3.6 Installation of more than one
hob
Supplied accessories: connection bar,
sealing stripe.
Use only a special heat-resistant silicone.
The worktop cutout
Distance minimum 50 mm
from the wall
Length 490 mm
Width the sum of all widths of appliances
that you install minus 20 mm
Example:
+ -
360 mm 360 mm
Assembly
• Calculate correct cutout dimensions.
• Prepare the worktop cutout.
• Place the appliances on a soft surface
(e.g. a blanket) with the bottom side up.
• In the case of the Teppan Yaki, attach the
supplied seal stripe to its lower edge,
along the outer edge of the glass ceramic.
Loosely screw the fixing plates into the
correct holes in the protection casing.
• Insert the first appliance into the worktop
cutout. Mount the connection bar under
the appliance so that a half of its width is
still visible - it will support the next
appliance.
• For the Teppan Yaki, loosely screw in the
fixing plates to the worktop from below (at
the front and the rear of the appliance).
=
20 mm 700 mm