Metabo BHE 22 Instrucciones De Manejo página 14

END ENGLISH
Electronic signal indicator (9) with
VTC electronics (KHE 28, KHE 26, BHE 26)
Rapid flashing - restart protection
When power is restored after a power supply
failure, for reasons of safety the still switched-on
machine will not start. To continue operation
switch the machine off, then on again.
Slow flashing - carbon brushes wom
The carbon brushes are almost completely wom. If
the brushes are completely worn, the machine
switches off automatically. Have the brushes
replaced by an authorized service centre.
12 Accessories
Use only genuine Metabo accessories,
If you need accessories, check with your dealer.
For the dealer to select the correct accessory, he
needs to know the exact model designation of
your power tool.
See page 4.
A Tools with SDS-Plus shank
B Twist drills for metal and wood
C TCT core cutter
D Dust extraction kit
E Special Grease
F Metabo CODE! Key
13 Repairs
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please attach a description of the fault to the
power tool.
14 Environmetal Protection
Metabo's packaging can be 100% recycled.
Worn out power tools and accessories contain
considerable amounts of valuable raw and plastic
materials, which can be recycled.
These instructions are printed on chlorine-free
bleached paper.
14
15 Technical Specifications
Explanatory notes on the information on page 2.
Changes due to technological progress reserved.
Р, = rated input
Р, = rated output
ny = no-load speed
По = load speed
omax = max. solid dritl diameter
smax = max. impact rate
W = single impact strength
m = weight
D = Spindle collar diameter
b = drill chuck chucking capacity
Typical A-weighted sound levels:
Loa = sound pressure level
Lwa = sound power level
During operation, the acoustic level may
exceed 85 dB(A).
N Wear hearing protection!
Anw = typical weighted acceleration in the
hand-arm area
Measured values established according to
ЕМ 50144.
The stated technical specifications are subject to
tolerances {as specified in the respective current
standards).