Hilti TE 4-A22 Manual De Instrucciones Original página 26

Trouble or fault
The battery runs down more
quickly than usual.
The battery does not en-
gage with an audible "double
click".
The rotary hammer or the
battery gets very hot.
The insert tool can't be re-
leased.
The tool makes no progress.
9 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
10 RoHS (Restriction of Hazardous Substances)
Click on the link to go to the table of hazardous substances: qr.hilti.com/r3159232.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
11 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
22 English
Possible cause
Very low ambient temperature.
The retaining lugs on the battery
are dirty.
Electrical fault.
The rotary hammer has been over-
loaded (application limit exceeded).
The chuck is not pulled back fully.
The rotary hammer has been set to
reverse rotation.
The function selector switch is set
to "Drilling without hammering"
Action to be taken
▶ Allow the battery to warm up
slowly to room temperature.
▶ Clean the retaining lugs and refit
the battery.
▶ Switch off the rotary hammer
immediately. Remove the
battery and keep it under
observation. Allow it to cool
down. Contact Hilti service.
▶ Select a tool that is suitable for
its intended use.
▶ Pull the tool lock back as far
as it will go and remove the
accessory tool.
▶ Move the forward / reverse
selector switch to the "Forward"
position.
▶ Set the function selector switch
. to "Hammer drilling"
2100244
*2100244*
.