Beta 3030H/2T Instrucciones página 8

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE USING AIR HYDRAULIC JACK
ALWAYS WEAR SAFETY FOOTWEAR WITH PROTECTIVE TOE CAPS
ALWAYS WEAR MECHANICALLY RESISTANT PROTECTIVE GLOVES
TECHNICAL DATA
MAXMUM CAPACITY
MINIMUM PLATE HEIGHT
MINIMUM PLATE HEIGHT
HYDRAULIC JACK LENGTH
HANDLE LENGTH
MAXIMUM HYDRAULIC JACK WIDTH
OPERATING TEMPERATURE
WEIGHT
ASSEMBLY
2) Fit the handle into the jack clamp, being careful to align the slot with the screw hole. Tighten the screw onto the jack
clamp, to prevent the handle from being accidentally removed during use.
HOW TO USE HYDRAULIC JACK
Air bleeding
During transportation, or if the tool is overturned, some air may enter the hydraulic circuit.
For such reason, in case of operating defects, any air that has accumulated in the system can be removed, as follows:
• Pull the handle upwards and rotate it anti-clockwise; keep the handle in that position until the jack has been lowered
completely.
• Pull down the pedal; keep it in that position, while lifting the jack to the maximum height by means of the handle
• Pull the handle upwards and rotate it anti-clockwise; keep the handle in that position, until the jack has been lowered
completely. Release the pedal.
• Replace the plug.
• Replace the black tote tray.
If any air is still found in the jack, repeat the entire procedure.
8
2t
85 mm
780 mm
1010 mm
1100 mm
360 mm
-10°C +50°C
56,5 kg
EN I