Idiomas disponibles
Idiomas disponibles
Oven Door (cont.)
To remove the door:
NOTE: Door removal is not a requirement for installation
of the product but is an added convenience.
1. Fully open the door.
2. Pull the hinge locks down
toward the door frame, to
the unlocked position. A
tool, such as a small flat-
blade screwdriver, may
be required.
3. Firmly grasp both sides of
the door at the top.
4. Close door to the door
removal position. The
door should be open
approximately 3" with no
obstruction above the door.
5. Lift door up and out until
both hinge arms are clear
of the slots in the range
frame.
Oven Light
SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electrical power to the
WARNING
oven at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn.
BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot glass with
CAUTION
bare hands or a damp cloth can cause burns.
To Remove the Light Bulb
1. Turn the glass cover counterclockwise until the glass
is removed. Wearing latex gloves may offer a better
grip.
it straight out.
To Replace the Light Bulb
50 watts. Replace the bulb with the same type of bulb
that was removed. Be sure the replacement bulb is
rated 120 volts or 130 volts (NOT 12 volts) and has a
G9 base.
packaging. Do not touch the bulb with bare fingers. Oil
from skin will damage the bulb and shorten its life.
3. Push the bulb straight into the receptacle all the way.
4. Replace the glass cover. For improved lighting inside
the oven, clean the glass cover frequently using a
wet cloth. This should be done when the oven is
completely cool and the light is off.
5. Reconnect electrical power to the oven.
49-2001187 Rev. 0
Slot
Hinge lock
Pull hinge locks down to unlock
Removal position
To replace the door:
1. Firmly grasp both sides of the door at the top.
2. With the door at the same
angle as the removal position,
rest the notch in the bottom
of the left hinge arm on the
bottom edge of the left hinge
slot. The notch in the hinge
arm must be fully seated onto
the bottom of the slot. Repeat
for the right side.
3. Fully open the door. If the door will not fully open,
the notches in the bottoms of the hinge arms are not
seated correctly onto the bottom edge of the slot. Lift
the door off the range and
repeat the previous step.
4. Push the hinge locks down to
the locked position.
5. Close the oven door.
Receptacle
Glass cover
(on some models)
Receptacle
Hinge arm
Bottom
edge of
slot
Notch
Hinge
arm
Hinge
lock
Push hinge locks
down to lock
Socket
G9 Bulb
Tab
or cloth
27
