Power Supply Installation; Lock Release Installation - golmar Stadio Plus Manual De Instalación

94
I
nstalling the FA-PLUS, FA-805 and FA-PLUS/C power supplies.
3,5 x 25
DIN-7971
The power supply can be installed on a DIN 46277 guide
simply pressing it. To disassemble the power supply
from the DIN guide, use a plain screwdriver to lever
the flange as shown on the picture.
The FA-Plus/C model uses 6 units over DIN guide,
7 units the FA -805, and 10 units the FA-Plus model.
IMPORTANT: the maximum number of units that can be connected to a FA-Plus/C power
L
ock release installation.
If the lock release will be installed in a metal door, use a
Ø3,5mm. drill and tap the hole . In case of wood door,
use a Ø3mm. Drill .
IMPORTANT: lock release could be of 12Vd.c. or 12Va.c.

POWER SUPPLY INSTALLATION

3,5 x 25
DIN-7971
To install the power supply directly on the wall, drill two holes
of Ø6 mm. and insert the wallplugs.
Fix the transformer with the specified screws.
supply is 10, and 50 units in case of a FA-Plus model.
FA -805 could be used only for general entrance doorpanels.
Link power supplies to connect more units than the specified as it's shown
on page 109.

LOCK RELEASE INSTALLATION

See both connections on page 109.
The power supply must be installed in a dry and
protected place. It's recommended to protect
the power supply by using a thermo-magnetic
circuit breaker and to use a ground connection.
DIN 46277
3,5 x 25
DIN-7972
M 4 x 8
DIN-963