golmar Stadio Plus Manual De Instalación página 108

TELEPHONES PROGRAMMING
P
rogramming the telephones.
For T-940 Uno and T-740 Uno telephones:
Each apartment must have one master unit only; in case of parallel units configure them
as slaves, both monitors or telephones.
For all the telephones:
Press the door release pushbutton and with this button
pressed, pick up the handset.
To show that the system is ready for programming, the panel
will reproduce a sound and the LCD will display the
message
release push button can be released. Audio communication
with the door panel is enabled.
To program the telephone as master,
To program it as slave, press the door
Make a call to make sure that the telephone has been properly programmed.
Program the other telephones in the same way.
At the end of the program process, exit the configuration menu by pressing
the CANCEL key. If you forget to do this, the doorpanel will exit
automatically the menu after 90 seconds.
. At this moment, the door
program mode
Enter the code that will be used to call to
this telephone and press the bell key.
At this moment the panel and the telephone
handset will reproduce a sound.
hang up the handset.
release push button.
107