Idiomas disponibles
Idiomas disponibles
Detachable
parts
LatteGo
Lubrication of the
brew group
Water tank
Cleaning the brew group
Regular cleaning of the brew group prevents coffee residues from clogging up the internal circuits. Scan the
QR code on the cover of this booklet for support videos on how to remove, insert and clean the brew group,
or visit www.philips.com/coffee-care
Cleaning the brew group under the tap
1 Remove the brew group (see 'Removing and inserting the brew group').
2 Rinse the brew group thoroughly with water. Carefully clean the upper filter (Fig. 33) of the brew group.
3 Let the brew group air-dry before you place it back. Do not dry the brew group with a cloth to prevent
fibers from collecting inside the brew group.
Cleaning the brew group with the coffee oil remover tablets
Only use Philips coffee oil remover tablets.
1 Put a cup under the coffee spout. Fill the water tank with fresh water.
2 Put a coffee oil remover tablet in the pre-ground coffee compartment.
3 Tap the coffee icon and then press the aroma strength icon for 3 seconds to select the pre-ground coffee
function (Fig. 2).
4 Do not add pre-ground coffee. Press the the start/stop
cup of water has been brewed, unplug the machine.
5 Let the coffee oil remover solution act for at least 15 minutes.
6 Insert the mains plug back into a wall socket and switch on the machine to complete the brewing cycle.
Empty the cup.
7 Remove the water tank and open the service door. Remove the brew group (see 'Removing the brew
group from the machine') and rinse it thoroughly under the tap.
8 Reinsert the brew group and water tank and place a cup under the coffee spout.
9 Tap the coffee icon and then press the aroma strength icon for 3 seconds to select the pre-ground coffee
function (Fig. 2). Do not add pre-ground coffee. Press the start/stop
Repeat this twice. Empty the cup.
Lubricating the brew group
Lubricate the brew group every 2 months, to ensure that the moving parts continue to move smoothly.
1 Apply a thin layer of grease on the piston (grey part) of the brew group (Fig. 34).
2 Apply a thin layer of grease around the shaft (grey part) in the bottom of the brew group (Fig. 35).
3 Apply a thin layer of grease to the rails on both sides (Fig. 36).
When to clean
After every use
Every 2 months
Weekly
How to clean
Rinse LatteGo under the tap or clean it in the
dishwasher.
Consult the lubrication table and lubricate the brew
group with the Philips grease (see 'Lubricating the
brew group').
Rinse the water tank under the tap
button to start the brewing cycle. When half a
button to start the brewing cycle.
English
13
