Idiomas disponibles
Idiomas disponibles
5.
Install Water Filter in Water Tank.
6.
Place and secure the Water Tank.
GRINDING SYSTEM
For best results, regularly clean the Semi-Automatic Espresso Machine and accessories.
Unplug before servicing.
Failure to do so can result in death or electrical shock.
IMPORTANT: Unplug the Semi-Automatic Espresso Machine before cleaning. Allow the
appliance to cool completely before putting on or taking off parts, and before cleaning the
appliance.
NOTE: Do not use abrasive cleansers or scouring pads when cleaning the Semi-Automatic
Espresso Machine, parts, or accessories. Do not immerse the Semi-Automatic Espresso
Machine or cord in water or other liquids.
1.
Lift the bean hopper lid, twist the knob and lift the Bean Hopper to remove. Twist the
bottom lock to empty the Bean Hopper into another container.
2.
Replace the empty Bean Hopper and lid. Press the Grind Start/Stop Button (
the grinder until empty.
3.
Remove the Bean Hopper, locate the Wire Handle on the Top Burr, rotate and lift the
handle to remove Top Burr.
4.
Clean the Top Burr with the Cleaning Brush. Clean the bottom burr with a Brush or use a
vacuum cleaner to remove coffee residue.
5.
Clean the chute by sticking the wire side of the Cleaning Brush through the chute from
either end to clean away any grounds or residue.
6.
The Bean Hopper and bean hopper lid can be cleaned with warm, soapy water, then rinse
with clean water and dry with clean soft cloth.
7.
Align the Top Burr back in place and twist clockwise to secure. Replace the Bean Hopper
and the lid.
NOTE: Make sure that water never comes into contact with the Burr Grinder system.
BREWING SYSTEM
1.
Clean the Steam Wand after every use. Toggle the Mode Button to select Steam mode.
Position the Steam Wand over Drip Tray or into a cup. Press the
Brew Start/Stop Button (
Steam Wand exterior with a soft damp cloth.
2.
Wash the Drip Tray, Portafilter, Filter Baskets, Milk Pitcher, and Drip Tray plate in warm,
soapy water and rinse with clean water. Dry with a soft cloth.
3.
When the Drip Tray indicator rises and becomes visible above the surface of the Drip Tray
plate, empty the Drip Tray and rinse with warm water.
4.
Wipe the Semi-Automatic Espresso Machine housing, Cup Warmer Tray,
Accessory Storage Tray, and Group Head with a clean soft damp cloth.
PROGRAMMING WATER HARDNESS
Before proceeding with programming, you will need to know your water hardness.
If you do not know your water hardness, you can purchase a water hardness test kit.
To configure the water hardness:
6
WARNING
Electrical Shock Hazard
), wait 2 to 3 seconds. Press it again to stop. Wipe down
) to run
