Idiomas disponibles
Idiomas disponibles
6.1
Switching on
CAUTION
Risk of injury Loss of control over the product.
▶ Before operating the product, check that the side handle, clamping flange, blade cover and the screws
retaining the saw blade cover and all other screws are secure.
1. Press the rear section of the on/off switch.
2. Slide the on/off switch forward.
▶ The motor runs.
3. Lock the on/off switch.
6.2
Cutting rebar
4
WARNING
Risk of injury Incorrect placement or cutting speed can cause serious injury and damage to the motor's
electronics.
▶ When cutting, slow down the forward (cutting) movement both at the start and approaching the end of
the cut.
▶ Hold the product firmly so that it does not vibrate when cutting.
▶ Do not start cutting immediately after the motor is switched on. Allow the saw blade to reach full speed
before starting the cut.
▶ Do not touch the rotating parts as they can cause serious injury.
▶ Do not cut rebar with a diameter of less than 4 mm.
▶ Do not cut rebar less than 10 mm in length, as the off-cut can stick between the saw blade and the cover
which can cause damage and possibly serious injury.
1. Check that the switch is at the O position (1).
2. Choose the most suitable setting for the intended cut (2).
Select setting 6 for highest cutting speed. Select a lower setting to reduce sparking.
3. Switch on the product. → page 27
4. Fit the rebar tightly against the guide. Slowly ease the product forward to start cutting the rebar (4).
5. After finishing the cut, switch off the product. → page 27
6.3
Switching off
▶ Press the rear section of the on/off switch.
▶ The on/off switch jumps into the off position and the motor stops.
7
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
•
Carefully remove stubborn dirt.
•
Carefully clean the air vents, if present, with a dry, soft brush.
•
Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
•
Use a dry, clean cloth to clean the contacts of the product.
Care of the Liion batteries
•
Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
*2412886*
2412886
English
27
