Idiomas disponibles
Idiomas disponibles
5.5
Replacing saw blade
Make sure that the Hilti NRC Xcut 110/4.3" saw blade is used. Use only saw blades that are in perfect
condition.
1. Fit the saw blade on to the output shaft. Make sure that the four positioning pins in the output shaft
engage the holes in the saw blade.
Check the saw blade teeth and machine settings and the direction of rotation. Do not use a saw
blade with teeth reduced to less than 1 mm.
2. Insert the new clamping flange.
3. Insert the new clamping screw.
4. Push in the spindle lock button completely and tighten the screw with the hex key.
Ensure that the spindle lock button is completely pushed in. If not, the saw blade can rotate and
cause injury.
5. Insert the new blade cover with 4 retaining sews and tighten the screws with the hex key.
5.6
Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap #2293133 and the Hilti
tool tether #2261970.
▶ Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
5.7
Installing or removing the chip collection bag
1. To install, push the adapter of the chip collection bag on to the chip collection bag holder until it engages
with an audible click.
2. To remove, open both clamps on the adapter of the chip collection bag slightly outwards.
5.8
Installing side handle
▶ Screw the side handle into one of the threaded holes.
5.9
Adjusting opening width
1. Loosen the width adjusting screw.
2. Move the width adjusting block left or right to obtain the desired opening width.
6
Operation
Observe the safety instructions and warnings in this documentation and on the product.
26
English
3
2412886
*2412886*
