Bosch 1640VS Instrucciones De Funcionamiento Y Seguridad página 9

If necessary, wipe the blade clean. Only then
should the saw teeth protector be removed.
Insert plug into power source and turn tool
on briefly (See Operating Instructions
Section). This will allow the saw blade pin to
engage into the blade, which drives the
blade back and forth. Turn tool off.
To change the blade, place the saw teeth
protector onto the blade and press the "Clic "
button. This causes the tab to spring out of
the locking spring, then remove the blade.
Assembly of Miter Table Attachment
MOUNTING MITER (Model 1640VSK only)
TABLE ATTACHMENT USING CLAMPS
Remove the thumbscrew from the storage
area located on the underside of the miter
table fixture (Fig. 2).
Place the stop on the table attachment
against the edge of the workbench or table,
and fasten the miter table attachment with
the aid of the two matching table clamps. To
do this properly, slide the table clamps in
completely in (Fig. 9).
FIG. 9
STOP
TABLE
CLAMP
When repacking the case (included with
model 1640VSK), place the table clamps
below the miter table attachment.
FIG. 8
SMALL
TAB
LARGE TAB
MOUNTING MITER TABLE ATTACHMENT
WITH SCREWS
Your miter table attachment is equipped with
two mounting holes that will allow you to
more permanently mount the miter table
attachment to a surface without the use of
the table clamps (Fig. 10). To attach, simply
screw two screws of sufficient length (not
provided) through the two holes provided in
the miter table attachment and into the
mounting surface.
FIG. 10
MOUNTING
SCREW HOLE
TABLE
CLAMP
ATTACHING THE SAW
Place the tool as shown in figure 2 on the
pivoting saw holder of the turntable and
secure with thumbscrew. Make sure that
the guide pins located on the miter table
attachment engage in the holes on the tool.
-9-
HOOK
DRIVE PIN
LOCKING
SPRING
MOUNTING
SCREW HOLE